User manual

14
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
LED INDICATOR
OPERATION LED STATUS SOUND AT POWER UP
Stop OFF
Forward Blinks
Forward (full speed) Solid
Reverse Blinks
Brake Blinks
Brake (full brake) Solid
Ni-MH/Ni-Cd Battery 1 Short Beep
2S Li-Po Battery 2 Short Beeps
ESC Ready 1 Long Beep
Battery Low Voltage Blinks
Overheat Blinks
PROGRAMMING THE ESC
The ESC comes with two jumpers pre-installed in the
REV: ON and BATT: Ni-MH configurations. To disable reverse
or change the battery type to Li-Po, disconnect the jumper
from the default port and connect it to the desired port. Power
o the ESC, then power it on again. If the jumpers are lost or
not installed, the ESC will default to REV: ON and BATT: Li-Po.