Owner`s manual

6
INTRODUCTION
The 545 hp, twin-turbocharged Nissan
GT-R has quickly established itself as
one of the most incredible street ma-
chines on the planet. The GT-R Nismo
GT3 shares the same engine with its
street legal sibling, but has been built
exclusively for FIA GT3 competition by
the Nismo motorsport arm of Nissan. In
place of creature comforts like adjust-
able leather seats and air condition-
ing are lightweight carbon fiber door
panels, a roll cage and racing harness.
Aerodynamic enhancements like a
front splitter, flat floor and adjustable
rear wing add extra down force at high
speeds. It all adds up to a world-class
racing machine that can go toe-to-toe
with Europe’s best and win.
Experience the thrill of GT3 class racing
with this outstanding, ready-to-run
replica of the 2012 Nissan GT-R Nismo
GT3. It comes just as you see here with
an ocially licensed GT3 body in place.
Underneath the body is a versatile
Vaterra V100-C chassis with a built-in
front splitter and rear diuser, just like
those on full-scale racing machines.
Handling is neutral out of the box, but
the chassis oers all kinds of tuning
options that let you tailor the handling
to your driving style. While the battery
is charging, take a little time and read
this manual. In its pages you’ll find help-
ful setup and charging tips as well as
a handy troubleshooting guide. It’s all
here to make sure your experience at
the wheel is the best it can be.
TABLE OF CONTENTS
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
QUICK START
/ / / / / / / / / / / / / / / / / / / / /
Please read the entire manual to gain a full understanding
of the V100 sedan, fine-tuning the setup, and performing
maintenance.
1 Read the safety precautions found in this manual.
2 Charge the battery. Refer to the included charging
warnings and instructions for battery charging
information.
3. Install the AA batteries in the transmitter.
Only use alkaline or rechargeable batteries.
4 Install the fully charged battery in the vehicle.
5 Power ON the transmitter and then the vehicle. Always
power the transmitter ON before the vehicle and power
it OFF after the vehicle has been powered OFF.
6 Check the steering and throttle control directions.
Verify that the servos are moving in the correct
direction.
7 Drive your vehicle.
8 Perform any necessary maintenance.
Introduction
Quick Start
Components
The Vehicle Battery
The Transmitter
Transmitter and Receiver Binding
Control Test
Run Time
Tuning, Adjusting & Maintaining Your Vehicle
Dynamite Li-Po Tazer 12T Waterproof Forward/Reverse ESC
Dynamite 15T Brushed Motor
Troubleshooting Guide
Limited Warranty
FCC Statement
Compliance Information for the European Union
Fasteners
Replacement Parts
Optional Parts
6
6
7
8
9
11
11
12
12
13
15
16
17
19
19
67
68
80