Owner`s manual

EN
THE TRANSMITTER
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
CAUTION: NEVER remove the
transmitter batteries while the
vehicle is powered ON, as loss of
control, property damage or injury
may result.
TRANSMITTER AND RECEIVER BINDING
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
Your Spektrum DX2L comes
prebound to the vehicle.
If you encounter problems, obey
binding instructions and refer to the
transmitter troubleshooting guide
for other instructions. If needed,
contact the appropriate Horizon
Product Support oce.
BINDING PROCEDURE
1 Make sure the transmitter and vehicle
are both powered OFF.
2 Install a bind plug in the receiver
battery/bind port. You do not need to
remove any of the other plugs to
re-bind.
3 With the bind plug installed, power ON
the vehicle. The receiver LED will flash
green.
4 With the steering and throttle in the
desired preset failsafe positions
(neutral), press and hold the bind
button and power ON the transmitter.
The transmitter’s red LED will flash
after 4 seconds when the transmit-
ter is in bind mode. Release the bind
button once the red LED flashes. Con-
tinue holding the failsafe positions
until the binding process is complete.
5 When the receiver binds to the
transmitter, the receiver LED will
turn solid.
6 Power OFF the vehicle, then the
transmitter.
7 Disconnect the battery from the ESC.
Remove the bind plug from the
receiver.
8 Safely store the bind plug in the bind
plug compartment in the transmitter.
9 The receiver will keep the binding to
the transmitter until another binding
is done.
INSTALLING THE TRANSMITTER BATTERIES
1 Push in the battery cover a small
amount to release the retaining tab,
then remove the cover.
2 Install 4 AA batteries, taking care
to align the battery polarity to the
diagram in the transmitter’s
battery case.
3 Carefully reinstall the battery cover
by aligning the tabs with the slots
on the transmitter.