Quick start guide

Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • [e-mail] DocID: 522506_25.02.2022
VP-m5 Mobile Video BiLight
EN
Technical specications
Light source 66 × SMD-LED (33 × warm white, 33 × cold white)
Light source properties Colour temperature 2550-6140K, steplessly adjustable
Colour rendering index CRI >95
Optical properties Beam angle 120°
Light output 800lm
Input connections Charging port USB-C
Power consumption LEDs 5W
Power supply USB (5V )
Battery / rechargeable battery Battery type Lithium-Ion
Voltage 3.7V
Capacity 2000mAh
Charging time 3.5h
Operating time 210h (depending on brightness setting)
Protection class IP20
Mounting options camera hot shoe
Mounting options (W × H × D) 92 mm×21 mm×78 mm
Weight 110g
Ambient conditions Temperature range 0 °C40°C
Relative humidity 2080% (non-condensing)
For the transport and protective packaging, environmentally friendly materials
have been chosen that can be supplied to normal recycling. Ensure that plastic
bags, packaging, etc. are properly disposed of. Do not just dispose of these ma-
terials with your normal household waste, but make sure that they are collected
for recycling. Please follow the notes and markings on the packaging.
This product is subject to the European Waste Electrical and Electronic Equip-
ment Directive (WEEE) in its currently valid version. Do not dispose of your old
device with your normal household waste. Dispose of this product through an
approved waste disposal rm or through your local waste facility. Comply with
the rules and regulations that apply in your country. If in doubt, consult your
local waste disposal facility.
Batteries must not be disposed of as domestic waste or thrown into re. Dis-
pose of batteries according to national or local regulations regarding hazard-
ous waste. Dispose of empty batteries at appropriate collection sites. Dispose
lithium batteries only in discharged condition. Remove replaceable lithium
batteries from the device before disposal. Protect used lithium batteries from
short circuits, for example by covering the poles with adhesive tape. Perma-
nently installed lithium batteries must be disposed of together with the device.
Please inquire about a suitable acceptance point.
Using the product
1. First the internal battery must be charged. To do this, connect the device to a
suitable voltage source (not supplied) via its USB-C port e.
2. Place the device with its connection w on the hot shoe of the camera to be used.
3. Press the
switch t to switch on the device.
4. Set the desired lighting intensity with the brightness control r.
5. Set the desired colour temperature between 2600  5700K with the colour
temperature control y.
6. Observe the battery charge level indicator q to estimate the remaining operat-
ing time. If the video light goes out, the internal battery must be recharged.
7. Press the
switch t to switch o the device.