User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 8 Technical specifications
- 9 Plug and connection assignment
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
7.2.2 DMX mode
This setting is only relevant if the device is controlled via a DMX controller.
1. Press [UP] or [DOWN] until the display shows ‘DMX CH Mode’ and conrm the selection
with [ENTER].
2. Press [UP] or [DOWN] to select the desired DMX mode ( ‘4CH’ or ‘8CH’ ) and conrm the
selection with [ENTER].
7.2.3 Master / slave mode
1. Press [UP] or [DOWN] until the display shows ‘Slave Mode’ and conrm the selection with
[ENTER].
2. Press [UP] or [DOWN] and select ‘ON’ ("Master/Slave" enabled) or ‘OFF’ ("Master/Slave"
disabled) and conrm the selection with [ENTER].
3. Press [MENU] to return to the parent menu level.
Operating
VP-1 FC DMX Video RGB + WW Panel
31
LED spotlight