User manual

1. Press [M].
2. Press one of the arrow buttons repeatedly until the display shows ‘MASL’ and conrm
with the selection with [OK].
3. Press one of the arrow buttons repeatedly until the display shows ‘SL’ and conrm with
the selection with [OK].
4. Use the arrow buttons to select a value between 1 and 512 (display shows ‘A001’ …
‘A512’ ).
ð
The number of the device with which the device is addressed as slave by the master
is set. This setting is only relevant if the device is operating as Slave controlled by a
Master, but not via DMX.
5. Conrm the selection with [OK]. Use [M] to return to the parent menu.
6. To return to the parent menu without changes press [M] without prior conrmation.
Slave mode
Operating
32
Starstrip 10 Active DMX
blinder