User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
Push the lock of the battery holder towards the centre of the housing and pull out the battery
holder like a drawer. Insert the batteries. Check for correct polarity as shown on the back of the
remote control. Slide the battery holder back into the remote until it clicks into place.
When shipping, the batteries are already installed in the remote and protected against dis‐
charge by a transparent plastic lm. Remove the plastic lm before initial use.
NOTICE!
Risk of re due to incorrect polarity
Incorrectly inserted batteries may destroy the device or the batteries.
Ensure that proper polarity is observed when inserting batteries.
NOTICE!
Possible damage by leaking batteries
Leaking batteries can cause permanent damage to the device.
Take batteries out of the device if it is not going to be used for a longer period.
Inserting batteries into the
remote
Installation
Sidus X6 HEX
19
LED PAR