User manual

7 Operating
7.1 Starting the device
To start operation, connect the device to the mains. The device is immediately operational.
The set values are retained during a power supply interruption.
7.2 Operating modes
This setting is only relevant when the device is controlled via DMX.
n Press [MENU] repeatedly until the display shows ‘Address’ . Conrm with [ENTER].
Use [UP] and [DOWN] to set the desired DMX address in a range from ‘001’ … ‘512’ and
conrm with [ENTER].
n Press [MENU] repeatedly until the display shows ‘CH Mode’
. Conrm with [ENTER].
Use [UP] and [DOWN] to select a DMX mode ( ‘05CH’ , ‘08CH’ or ‘21CH’ ) and conrm with
[ENTER].
n Press [MENU] repeatedly until the display shows ‘Mode’ . Conrm with [ENTER].
Use [UP] or [DOWN] to select the menu item ‘DMX’ and conrm with [ENTER] to enable the
DMX mode.
Make sure that the DMX address number matches the conguration of your DMX controller.
The following table shows the highest possible DMX address for the various DMX modes.
Operating mode ‘DMX’
Operating
20
Retro Blinder 80 LED
Blinder