User manual

This setting is only relevant if the device is working as Slave in a Master / Slave conguration
and is not controlled via DMX.
Press [MENU] repeatedly until the display shows ‘SLA’ . Use [UP] or [DOWN] to select the option
‘S001’ to enable the Slave mode.
Conrm with [ENTER]. Now you can set the Slave address. Use [UP] and [DOWN] to select a
value between ‘001’ … ‘512’ and conrm with [ENTER].
To activate the ‘Master’ mode in synchronous mode, proceed as follows:
Press [MENU] repeatedly until the display shows ‘SYS’ . Use [UP] or [DOWN] to select the option
‘M-En’ and conrm with [ENTER]. Use [UP] or [DOWN] to select the option ‘On’ to enable the
operation mode. Conrm again with [ENTER] to apply the setting.
To initiate the self-test function, proceed as follows:
Press [MENU] repeatedly until the display shows ‘SYN’ . Use [UP] or [DOWN] to select the option
‘tESt’ and conrm with [ENTER] to initiate a self-test.
Operating mode ‘Slave’
Operating mode ‘Master’
Self test
Operating
LED Pad Bar Compact ST RGB
35
LED lighting set