User manual

In sound mode, you have the option to activate one of twelve coloured LED shows, one of ten

available stroboscope LED shows and one of three show programmes. This setting is only rele‐

vant if the device is not controlled via DMX. The programme control is based on the signals

received via the built-in microphone. The sensitivity of the built-in microphone is set manually

via the controller on the device.

Press [MENU] repeatedly until the display shows ‘Sou’ .

Use [UP] or [DOWN] to select the submenu ‘SouP’ . Conrm with [ENTER] and use [UP] or

[DOWN] to select one of 12 LED shows ‘SP01’ … ‘SP12’ . Conrm with [ENTER]. The display

shows ‘Sxx’ . Use [UP] or [DOWN] to set the programme speed in a range from ‘S01’ (slow) to

‘S99’ (fast). Conrm again with [ENTER] to apply the setting.

Use [UP] or [DOWN] to select the submenu ‘SouF’ . Conrm with [ENTER] and use [UP] or

[DOWN] to select one of ten stroboscope shows ‘SF01’ … ‘SF10’ . Conrm with [ENTER]. The

display shows ‘Sxx’ . Use [UP] or [DOWN] to set the programme speed in a range from ‘S01’

(slow) to ‘S99’ (fast). Conrm again with [ENTER] to apply the setting.

Use [UP] or [DOWN] to select the submenu ‘SouM’ . Conrm with [ENTER] and use [UP] or

[DOWN] to select one of three preprogrammed shows ‘SM01’ … ‘SM03’ . Conrm with [ENTER].

The display shows ‘Sxx’ . Use [UP] or [DOWN] to set the programme speed in a range from ‘S01’

(slow) to ‘S99’ (fast). Conrm again with [ENTER] to apply the setting.

Operating mode ‘Sound’

Operating

LED Pad Bar Compact ST RGB

LED lighting set