User manual

Press [MENU]. Press [UP] / [DOWN] repeatedly until the display shows ‘SLAv’ . Press [ENTER]. The
display now shows ‘SLA’ . The device is now congured as slave and follows the settings of the
master device to which it is connected. In the other operating modes, the device automatically
operates as master. Press [MENU] to return to the parent menu. This setting is only relevant if
the device is not controlled via DMX.
Press [MENU]. Press [UP] / [DOWN] repeatedly until the display shows ‘rEno’ . With [UP] /
[DOWN] you can now either enable (display shows ‘ON’ ) or disable (display shows ‘OFF’ ) the
remote control function. When the display shows the desired value press [ENTER] to conrm
the selection and then [MENU] to return to the parent menu. To return to the parent menu
without making changes, press [MENU].
Press [MENU]. Press [UP] / [DOWN] repeatedly until the display shows ‘tEnP’ . Press [ENTER]. The
display shows the current operating temperature.
Press [MENU]. Press [UP] / [DOWN] repeatedly until the display shows ‘Uer’ . Press [ENTER]. The
display now shows the current software version with ‘XXX’ . To return to the parent menu,
press [MENU].
Operating mode ‘Slave’
Remote control
Temperature
Software version display.
Operating
40
LED Pad 7 7x10W 5in1 RGBWA
LED PAR