User manual

Press [MENU]. Press [UP] / [DOWN] repeatedly until the display shows ‘Auto’ . Press [ENTER].
With [UP] / [DOWN] you can now select one of the two preprogrammed automatic shows
‘AUT1’ or ‘AUT2’ . Press [ENTER]. Use [UP] / [DOWN] to select a value for the programme speed
between 1 and 9 (display shows ‘SP1’ … ‘SP9’ ). Press [ENTER]. Then use [UP] / [DOWN] to select
a value for the strobe frequency between 00 and 99 (display shows ‘St00’ … ‘St99’ ). When the
display shows the desired value press [ENTER] to conrm the selection and then [MENU]to
return to the parent menu. To return to the parent menu without making changes, press
[MENU].
This setting is only relevant if the device is not controlled via DMX. The device can operate in
stand-alone mode or control connected devices of the same type, that must be congured as
slaves. The auto show can only be activated on the master device.
Press [MENU]. Press [UP] / [DOWN] repeatedly until the display shows ‘CoLo’ . Press [ENTER].
With [UP] / [DOWN] you can now select a colour ‘CoL1’ to ‘CoL51’ . When the display shows the
desired value press [ENTER] to conrm the selection. Then use [UP] / [DOWN] to select a value
for the strobe frequency between 00 and 99 (display shows ‘St00’ … ‘St99’ ). When the display
shows the desired value press [ENTER] to conrm the selection and then [MENU] to return to
the parent menu. To return to the parent menu without making changes, press [MENU].
Operating mode ‘Auto 1’ / ‘Auto
2’
Colour selection
Operating
38
LED Pad 7 7x10W 5in1 RGBWA
LED PAR