User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 7.1 Starting the device
- 7.2 System settings
- 7.3 Stand-alone mode
- 7.4 DMX operation
- 7.5 Menu overview
- 7.6 Functions in 2-channel DMX mode
- 7.7 Functions in 3-channel DMX mode
- 7.8 Functions in 4-channel DMX mode
- 7.9 Functions in 7-channel DMX mode
- 7.10 Functions in 9-channel DMX mode
- 7.11 Functions in 14-channel DMX mode
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
Press [MENU] and then [UP] or [DOWN] until the display shows ‘DMX’ .
With [UP] or [DOWN] you can now select one of the following DMX modes:
n ‘2CH’ (two channels)
n ‘3CH’
(three channels)
n ‘4CH’ (four channels)
n ‘7CH’
(seven channels)
n ‘9CH’ (nine channels)
n ‘14CH’
(14 channels)
Conrm the desired selection with [ENTER].
This setting is only relevant when the device is controlled via DMX.
Selecting the DMX mode.
Operating
LED Ball RGBW 50cm 4x8W DMX
41
LED ball