User manual

CAUTION!
Risk of injury due to mirror movements
The mirror mounted at the device head may perform very fast movements (pan, tilt) and reect very bright light. This is also the case
immediately after switching on the device, with automatic or remote operation, and while a connected DMX controller is in o state.
Persons who are in the immediate vicinity of the device may be injured or frightened by this. Make sure that there are no obstacles
within the movement range of the mirror, and that no persons are in the immediate vicinity of the device before switching it on and
during its operation. If any work is to be carried out within the movement range or in the immediate vicinity of the mirror, the device
must remain switched o.
NOTICE!
Risk of re
Do not block areas of ventilation. Do not install the device near any direct heat source. Keep the device away from naked ames.
NOTICE!
Risk of overheating
The distance between light output and the illuminated surface must be more than 1.5 m (19.7in). Provide sucient ventilation. The
ambient temperature must always be below 40 °C (104 °F).
NOTICE!
Operating conditions
This device has been designed for indoor use only. To prevent damage, never expose the device to any liquid or moisture. Avoid
direct sunlight, heavy dirt, and strong vibrations. Only operate the device within the ambient conditions specied in the chapter
‘Technical specications’ of this user manual. Avoid heavy temperature uctuations and do not switch the device on immediately
after it was exposed to temperature uctuations (for example after transport at low outside temperatures). Dust and dirt inside can
damage the unit. When operated in harmful ambient conditions (dust, smoke, nicotine, fog, etc.), the unit should be maintained by
qualied service personnel at regular intervals to prevent overheating and other malfunction.
Safety instructions
Hero Scan 150
13
LED Scanner