User manual

7.4 Settings
Use the ‘Setting’ menu to adjust the device parameters.
1. Press [SET] to activate the main menu.
2. Press [UP] or [DOWN] until the display shows ‘Setting’ and conrm the selec‐
tion with [SET].
3. Press [UP] or [DOWN] to select the desired submenu or the desired value and
conrm the selection with [SET].
The following sub menus are available:
Menu level 2 Menu level 3/4 Description
‘Pan Reverse’ Pan inversion
‘YES’ reversed direction of rotation
‘NO’ normal direction of rotation
‘Tilt Reverse’ Tilt inversion
‘YES’ reversed direction of inclination
‘NO’ normal direction of inclination
‘Pan Limit’ ‘Starting point’
‘0’ … ‘539’
Starting point of the rotation angle
‘Ending point’
‘1’ … ‘540’
Ending point of the rotation angle
‘Tilt Limit’ ‘Starting point’
‘0’ … ‘249’
Starting point of the inclination angle
‘Ending point’
‘1’ … ‘250’
Ending point of the inclination angle
‘Home Position’ Setting the start parameters
Detailed information about this menu item can be found
under Ä ‘Setting the start parameters’ on page 24.
‘DMX Fail’ Behaviour on DMX control failure
‘Hold’ last DMX signal is being held
‘Blackout’ Blackout on DMX failure
‘Auto Mode’ Automatic programmes mode on
DMX failure
‘Manual Control’ Manual mode on DMX failure
‘Sound Mode’ Sound control on DMX failure
‘Dimmer Curve’ Setting the dimmer curve
‘Linear’ linear proportional course
Operating
Hero Beam 100
21
moving head