User manual

Use the ‘DMX Address’ menu to set the DMX address. This setting is only relevant if
the device is controlled via a DMX controller.
1. Press [SET] to activate the main menu.
2. Press [UP] or [DOWN] until the display shows ‘DMX Address’ and conrm your
selection with [SET].
3. Press [UP] or [DOWN] to select a value between 1 and 512 for the desired DMX
address (display shows ‘001’ … ‘512’ ) and conrm the selection with [SET].
Make sure that this number matches the conguration of your DMX controller.
The following table shows the respective highest possible DMX address for the
various DMX modes.
Mode Highest possible DMX address
6-channel mode 507
19-channel mode 494
7.3 Operating modes
Use the ‘Running Mode’ menu to set the operating modes.
In this mode the device is controlled via a DMX controller.
1. Press [SET] to activate the main menu.
2. Press [UP] or [DOWN] until the display shows ‘Running Mode’ and conrm the
selection with [SET].
3. Press [UP] or [DOWN] to select the desired DMX mode and conrm the selec‐
tion with [SET].
The following DMX modes are available:
Menu level 2 Description
‘DMX 6CH mode’ 6-channel mode
‘DMX 19CH Mode’ 19-channel mode
Setting the DMX address
Setting the DMX mode
Operating
Hero Beam 100
17
moving head