User manual

7 Operating

7.1 Starting the device

CAUTION!

Risk of injury due to movements of the device

The head of the device can move quickly (pan, tilt) and can produce

very bright light. This is also valid immediately after you turn on the

device, when the device operates in automatic mode or under remote

control and when you turn o a DMX controller that is connected to the

device. Persons staying near the device could be injured or frightened.

Before you turn on the device and during the operation, always ensure

that nobody stays close to the device. If work has to be performed in the

area of movement or in the near vicinity of the device, it must remain

turned o.

Connect the device to the power supply to start operation. After a few seconds, the

fans start to work, the head moves to the home positions for rotation (pan) and incli‐

nation (tilt). The device is now operational.

7.2 Main menu

1. Press [SET] to activate the main menu.

2. Press [UP] or [DOWN] to change the respectively displayed value.

3. When the display shows the desired value, press [SET].

4. To exit a menu item without making changes, press [ESC].

If you don't press any button for 60 seconds the display turns o. A short press on

[ESC], [SET], [UP] or [DOWN] will then turn it back on.

All previous settings are retained even when you switch the device o and discon‐

nect it from the mains.

Operating

Hero Beam 100

moving head