User manual

5 Starting up

Create all connections while the device is o. Use the shortest possible high-quality

cables for all connections. Take care when running the cables to prevent tripping

hazards.

Connect the DMX input of the device to the DMX output of a DMX controller or

another DMX device. Connect the output of the rst DMX device to the input of the

second one, and so on to form a daisy chain. Always ensure that the output of the

last DMX device in the daisy chain is terminated with a resistor (110 Ω, ¼ W).

When the device and the DMX controller are in operation and a DMX signal is

received at the input, the status LED [DMX] lights up.

When you congure a group of devices in master/slave mode, the rst unit will con‐

trol the other units for an automatic, sound-activated, synchronized show. This func‐

tion is ideal when you want to start a show immediately. Connect the DMX output of

the master device to the DMX input of the rst slave device. Then connect the DMX

output of the rst slave device to the DMX input of the second slave device and so

on.

Connections in DMX mode

DMX indicator

Connections in master/slave mode

Starting up

Hero Beam 100

moving head