User manual

Push the lock of the battery holder towards the centre of the housing and pull out the battery
holder like a drawer. Insert the batteries in the correct polarity according to the marking on the
remote. Slide the battery holder back into the remote until it clicks into place.
When shipping, the batteries are already installed in the remote and protected against dis‐
charge by a transparent plastic lm. Remove the plastic lm before initial use.
NOTICE!
Risk of re due to incorrect polarity
Incorrectly inserted batteries may destroy the device or the batteries.
Ensure that proper polarity is observed when inserting batteries.
NOTICE!
Possible damage by leaking batteries
Leaking batteries can cause permanent damage to the device.
Take batteries out of the device if it is not going to be used for a longer period.
Inserting batteries into the
remote
Installation
18
Giga Bar HEX 3Giga Bar HEX 3 BAT
LED Bar