Quick start guide

Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • [e-mail] DocID: 415353_30.06.2021
Emergency Kill Switch
EN
Quick start guide
This quick start guide contains important information on the safe operation of the
product. Read and follow the safety advice and instructions given. Retain the quick
start guide for future reference. If you pass the product on to others please include this
quick start guide.
Safety instructions
Intended use
This device is intended to be used as a portable video light. Any other use or use
under other operating conditions is considered to be improper and may result in per-
sonal injury or property damage. No liability will be assumed for damages resulting
from improper use.
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are
not within reach of babies and young children. Choking hazard! Ensure
that children do not detach any small parts from the product. They could
swallow the pieces and choke!
Where to use the product
Never use the product
• in conditions of extreme temperature or humidity
• in extremely dusty or dirty areas
• at locations where the unit can become wet
General handling
• To prevent damage, never use force when handling the product.
• Never immerse the product in water. Just wipe it with a clean dry cloth. Do not
use liquid cleaners such as benzene, thinners or ammable cleaning agents.
Features
• Emergency kill switch for lasers without interlock and other devices with
protective contact plugs
• 1.4 m input cable and 5.8 m output cable
• Cable cross-section: 1.5 mm²
• Maximum load: 6 A
Using the product
1. Connect the device that you want to disconnect from the mains voltage supply
with the emergency stop switch to the protective contact coupling of the output
cable.
2. Connect the protective contact plug of the input cable to a properly wired mains
socket that provides the required voltage.
3. To trigger the emergency shutdown, press the emergency button of the kill
switch.
4. To release the switch again after it has been triggered and thereby restore the
power supply for the connected device, turn the button of the switch in the
direction indicated by the arrows engraved there.
Operating elements
Input cable
Output cable
Kill switch
For the transport and protective packaging, environmentally friendly materials
have been chosen that can be supplied to normal recycling. Ensure that plastic
bags, packaging, etc. are properly disposed of. Do not just dispose of these ma-
terials with your normal household waste, but make sure that they are collected for recy-
cling. Please follow the notes and markings on the packaging.
This product is subject to the European Waste Electrical and Electronic Equip-
ment Directive (WEEE) in its currently valid version. Do not dispose of your old
device with your normal household waste. Dispose of this product through an
approved waste disposal rm or through your local waste facility. Comply with
the rules and regulations that apply in your country. If in doubt, consult your local waste
disposal facility.