User manual

7.3.2 Setting the DMX mode
1.
Press to activate the main menu.
2.
Press or repeatedly until the display shows ‘DMX Mode’ . Conrm with .
3.
Use or to select the desired DMX mode ( ‘3CH’ , ‘6CH’ , ‘12CH’ , ‘16CH’ ,
‘56CH’ or ‘68CH’ ). Conrm with .
This setting is only relevant when the device is controlled via DMX.
7.3.3 ‘Automatic mode’
Auto mode can only be activated when the unit is operating in stand alone mode or
as master in a master / slave combination. This setting is only relevant if the device is
not controlled via DMX. 14 dierent show programmes are available in automatic
mode. Congure the sequence speed and the dimmer intensity of the automatic
mode.
1.
Press to activate the main menu.
2.
Press or repeatedly until the display shows ‘Stand Alone’ . Conrm with .
3.
Press or repeatedly until the display shows ‘Auto’ . Conrm with .
4.
Use or to select the desired show programme ( ‘Program 1’ …
‘Program 14’ ). Conrm with .
5.
Press or to select the desired submenu or the desired value.
The following sub menus are available:
Menu level 4 Menu level 5 Description
‘Dimmer’ ‘000…255’ Dimmer intensity
‘Speed’ ‘000…255’ Running speed from slow to fast
6.
Press to accept the selection.
7.3.4 Operating mode ‘Sound control’
Sound control mode can only be activated when the unit is operating in stand alone
mode or as master in a master / slave combination. This setting is only relevant if the
device is not controlled via DMX. In this operating mode, the device responds to
acoustic pulses which are recorded by the integrated microphone. Congure the
dimmer intensity and microphone sensitivity of the sound control.
1.
Press to activate the main menu.
2.
Press or repeatedly until the display shows ‘Stand Alone’ . Conrm with .
3.
Press or repeatedly until the display shows ‘Sound’ . Conrm with .
4.
Use or to select the desired show programme ( ‘Program 1’ …
‘Program 14’ ). Conrm with .
Operating
Colors NerveStrobe HP
15
Stroboscope