User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and operating elements
- 7 Operating
- 7.1 Starting the device
- 7.2 Navigating the menu
- 7.3 Operating on the unit
- 7.3.1 Setting the DMX address
- 7.3.2 Setting the DMX mode
- 7.3.3 ‘Automatic mode’
- 7.3.4 Operating mode ‘Sound control’
- 7.3.5 Master / slave mode
- 7.3.6 Setting colour macro
- 7.3.7 Setting dimmer and strobe effect for CW LEDs (WhiteBar)
- 7.3.8 Setting an individual mixed colour
- 7.3.9 Rotating the Display
- 7.3.10 Display lighting
- 7.3.11 Behaviour on DMX control failure
- 7.3.12 Dimmer curve
- 7.3.13 Key lock
- 7.3.14 Resetting the device to factory defaults
- 7.3.15 PWM (pulse width modulation)
- 7.3.16 Firmware version display
- 7.3.17 Operating hours display
- 7.3.18 LED temperature display
- 7.4 Menu overview
- 7.5 Functions in 3-channel mode
- 7.6 Functions in 6-channel mode
- 7.7 Functions in 12-channel mode
- 7.8 Functions in 16-channel mode
- 7.9 Functions in 56-channel mode
- 7.10 Functions in 68-channel mode
- 8 Technical specifications
- 9 Plug and connection assignment
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
5 Starting up
Create all connections while the device is o. Use the shortest possible high-quality
cables for all connections. Take care when running the cables to prevent tripping
hazards.
Connect the DMX input of the device to the DMX output of a DMX controller or
another DMX device. Connect the output of the rst DMX device to the input of the
second one, and so on to form a daisy chain. Always ensure that the output of the
last DMX device in the daisy chain is terminated with a resistor (110 Ω, ¼ W).
When you congure a group of devices in master/slave mode, the rst unit will con‐
trol the other units for an automatic, sound-activated, synchronized show. This func‐
tion is ideal when you want to start a show immediately. Connect the DMX output of
the master device to the DMX input of the rst slave device. Then connect the DMX
output of the rst slave device to the DMX input of the second slave device and so
on.
Connections in DMX mode
Connections in master/slave mode
Starting up
Colors NerveStrobe HP
11
Stroboscope