User`s guide

R.G.B.H.V.
BNC inputs for analog signals
These inputs allow monitor to
be used with BNC connector
leads with
3 wire operation
(sync on green)
4 wire operation
(composite syncs)
5 wire operation
(separate H,V syncs)
R,G,B inputs have 75Ω input
resistance. H,V inputs must be
TTL level inputs.
Signal Connections Cont.
The power and signal inputs to the monitor are located on the rear of the unit.
4
POWER INPUT
Connector: 3 pin circular locking type
Pin Number Function
1 +12VDC
2 0V
3 15-30VDC
DIN41524
3
1
2
Pin Number Function
1 Red video
2 Green Video
3 Blue Video
4 Not connected
5 Not connected
6 Red ground
7 Green ground
8 Blue ground
9 Not connected
10 Sync ground
SIGNAL INPUT
Standard hi-density 15way video connection
11 Not connected
12 Not connected
13 Horizontal sync
14 Vertical sync
15 Not Connected
TTL Input
This 9 way D connector allows monitor to operate with TTL
video from EGA/CGA PC’s or other TTL graphics cards.
Default factory setting is for 6 bit video. Factory set jumpers
can select 3 or 4 bit video if required.
Pin
Number
Function
3 bit video 4bit video 6 bit video
1 GND (0v) GND (0v) GND (0v)
2 NC NC Red Intensity
3 Red Red Red
4 Green Green Green
5 Blue Blue Blue
6 NC NC Green Intensity
7 NC NC Blue Intensity
8 Horizontal Sync Horizontal Sync Horizontal Sync
9 Vertical Sync Vertical Sync Vertical Sync
COMMS
This connector is used in the factory or by service
technician to program the monitor with setup
information. The User should not attempt to use
this connector.
2.3