User`s guide
VT170 DiamondVue User Guide 150-069
You can use an HD-15 connector cable or a BNC adapter cable to connect the flat panel
monitor to the host computer. The HD-15 video cable (supplied in the kit) you use with this
monitor is equipped with a conventional HD-15 connector at each end.
5
Note: The following figure is the view looking into the pin end of the male connector or solder
term end of the female connector.
Pin Signal Pin Signal Pin Signal
1 T.M.D.S. Data2- 9 T.M.D.S. Data1- 17 T.M.D.S. Data0-
2 T.M.D.S. Data2+ 10 T.M.D.S. Data1+ 18 T.M.D.S. Data0+
3 T.M.D.S. Data2/4 Shield 11 T.M.D.S. Data1/3 Shield 19 T.M.D.S. Data0/5 Shield
4 T.M.D.S. Data4- 12 T.M.D.S. Data3- 20 T.M.D.S. Data5-
5 T.M.D.S. Data4+ 13 T.M.D.S. Data3+ 21 T.M.D.S. Data5+
6 DDC Clock 14 +5V Power 22 T.M.D.S. Clock Shield
7 DDC Data 15 Ground (return for +5V, H. Sync and V. Sync) 23 T.M.D.S. Clock+
8 Analog Vertical Sync 16 Hot Plug Detect 24 T.M.D.S. Clock-
DVI-I
Pin Signal
C1 Analog Red
C2 Analog Green
C3 Analog Blue
C4 Analog H. Sync
C5 Analog Ground
DVI-I
DVI-I Connector
(Digital / Analog)
Pin Signal Pin Signal Pin Signal
1 Red Video 6 Red Video Ground 11 Not Used
2 Green Video 7 Green Video Ground 12 Bi-Directional Data
3 Blue Video 8 Blue Video Ground 13 Horizontal Sync
4 Not Used 9 No Connection 14 Vertical Sync
5 Return 10 Sync Ground 15 Data Clock (SCL)
HD15 Connector
The following table provides the pin numbers and corresponding pin assignments for
the HD-15 video connector.
17
9
1
8
16
24
C5
C4 C3
C2
C1
Composite Video Input Connector: CVBS 1.0V p-p
S-Video: S-VHS
LUMA Signal Input 0.7V p-p
CHROMA Signal Input 0.7V p-p
2.5
Signal Connections Cont.
HD15 Connector