User`s guide

VT150 DiamondVue/CrystalVue User’s Guide 150-178

MOUNTING INSTRUCTIONS

SECTION 7

7.1 Panel Mount Procedure

Mechanical Drawings

Model Description Page(s)

VT150P2 15.0" DiamondVue/CrystalVue Panel Mount Drawing (Nema 4) 16

VT150PS2 15.0" DiamondVue/CrystalVue Drawing (Nema 4x) 17

VT150R2 15.0" DiamondVue/CrystalVue Rack Mount Drawing 18

VT150C2 15.0" DiamondVue/CrystalVue Openframe 19

VT150W2 15.0" DiamondVue/CrystalVue Wall Mount 20

1. Cut and drill the panel (refer to panel mount drawing). Measurements are in inches.

2. If access to the side of the monitor is not available following installation, attach the power and video cables to the

side of the monitor at this time.

3. Install the monitor in the prepared cutout.

4. Install the lock nuts and washers, supplied with the monitor, behind the holes running along the sides and top/bottom

of the cutout in the panel. Extra lock nuts and washers are provided.