User`s guide

14
easily damage the surface. Never use alcoholic or ammoniac cleaners to clean the polycarbonate
shield or a touch screen.
Note:
For best results cleaning a monitor with the optional antireflective tempered glass display shield, a
solution of denatured alcohol is recommended to thoroughly clean the display.
Replacing a Line Cord
To avoid shock and fire hazards, the monitor’s power cord should be replaced if the insulation
becomes broken or if it develops a loose internal connection.
Other Maintenance
Qualified service personnel should perform all maintenance, except for the power cord replacement
described above.
SECTION 7
7.1 Panel Mount Procedure
Mechanical Drawings
Model
Description
Page(s)
VT104P2
10.4" DiamondVue/CrystalVue Panel Mount Drawing (Nema 4)
18
VT104PS2
10.4" DiamondVue/CrystalVue Panel Mount Drawing (Nema 4x)
19
VT104C2
10.4” DiamondVue/CrystalVue Open Frame
20
1. Cut and drill the panel (refer to panel mount drawing). Measurements are in inches.
Panel Mounting Cutout
2. If access to the side of the monitor is not available following installation, attach the power and video cables
to the side of the monitor at this time.
3. Install the monitor in the prepared cutout.
4. Install the lock nuts and washers, supplied with the monitor, behind the holes running along the sides and
top/bottom of the cutout in the panel. Extra lock nuts and washers are provided.