Safety data sheet

ManualsBrandsVARTA ManualsButton CellsButton cell SR69, SR921 Silver oxide Electronics SR69, hochstromfähig 30 mAh 1.55 V 1 pc(s)

Silver Oxide-

Safety Data Sheet Batteries

Edition: 2017-04-04 Version: 9 / Silver oxide

Silver Oxide - Batteries Page 1 of 6

1. IDENTIFICATION

Trade name: Primary Silver oxide battery: button cell (all sizes)

Voltage: 1,55 V ( or multiples of this in case of multi-cell configurations)

Electrochemical system: Zinc | NaOH/KOH electrolyte | silver oxide, manganese dioxide

Anode (negative electrode): Zinc

Cathode (positive electrode): Silver oxide, manganese dioxide

VARTA Consumer Batteries Alfred-Krupp-Str. 9, 73479 Ellwangen/Germany

GmbH & Co. KGaA Phone ++49 (0) 7961 / 83-0

Fax ++49 (0) 0800-827-8274

Emergency Telephone Number: ++49 (0) 911 / 65372260

...............................................................................................................................................................

2. HAZARDS IDENTIFICATION

A sealed zinc/silver oxide button cell is not hazardous in normal use (as defined in chapter 7).

In case of mistreatment (prolonged deep discharge, charge, reverse charge, external short circuit ... )

and in case of fault, some electrolyte can leak from the cell. In these cases refer to the risk of

potassium hydroxide solution or sodium hydroxide solution (corrosive, pH > 14). Charging may cause

rupture. The electrode materials are only hazardous, if the materials are released by mechanical

damaging of the cell or if exposed to fire.

GHS Classification : N/A

Summary of content (6 pages)

PAGE 1
Silver Oxide- Safety Data Sheet Batteries Edition: 2017-04-04 1. Version: 9 / Silver oxide IDENTIFICATION Trade name: Primary Silver oxide battery: button cell (all sizes) Voltage: 1,55 V ( or multiples of this in case of multi-cell configurations) Electrochemical system: Zinc | NaOH/KOH electrolyte | silver oxide, manganese dioxide Anode (negative electrode): Zinc Cathode (positive electrode): Silver oxide, manganese dioxide VARTA Consumer Batteries GmbH & Co.
PAGE 2
Silver Oxide- Safety Data Sheet Edition: 2017-04-04 3. Batteries Version: 9 / Silver oxide COMPOSITION / INFORMATION on INGREDIENTS ................................................................................................................................................... 4. FIRST AID MEASURES Contact to internal battery content: ► Skin: Flush affected areas with plenty of water. Remove contaminated cloth immediately. Seek for medical assistance.
PAGE 3
Silver Oxide- Safety Data Sheet Edition: 2017-04-04 5. Batteries Version: 9 / Silver oxide FIRE – FIGHTING MEASURES Suitable extinguishing media: Use foam, water, or CO2, as appropriate. Extinguishing media with limited suitability: (none) Special protection equipment during fire-fighting: Contamination cloth including breathing apparatus. Special hazard: (none) .....................................................................................................................................
PAGE 4
Silver Oxide- Safety Data Sheet Batteries Edition: 2017-04-04 Version: 9 / Silver oxide Storage: Storage preferably at room temperature (approx. 20°C). Avoid large temperature changes. Avoid direct sunlight. At higher temperature the electrical performance may be reduced. Storage of unpacked batteries can cause short circuit and heat generation. Storage of large amounts: If possible, store the batteries in original packaging (short circuit protection). A fire alarm is recommended.
PAGE 5
Silver Oxide- Safety Data Sheet Edition: 2017-04-04 Batteries Version: 9 / Silver oxide Mercury has not been “intentionally introduced (as distinguished from mercury that may be incidentally present in other materials)” in the sense of the U.S.A. “Mercury-Containing and Rechargeable Battery Management Act” (May 13 1996).
PAGE 6
Silver Oxide- Safety Data Sheet Edition: 2017-04-04 15. Batteries Version: 9 / Silver oxide REGULATORY INFORMATION Marking considerations: According to directive 2006/66/EC of the European Parliament and of the council of 6. September 2006 on batteries and accumulators and waste batteries and accumulators and repealing directive 91/157/EEC all batteries have to be marked with the crossed bin. Due to the size of the battery, this marking has to be placed on the packaging.