Operating instructions

POWXG9007

P a g e | 9

www.varo.com

10.3 Connect high pressure hose to spray gun and pump.

Fit the lance to the gun (picture 1, part 4). Grip the

end of the gun and screw the lance onto the gun

ensuring it is tight. Do not over tighten as this

could damage both the connectors.

Connect the high pressure hose connector to the

connector on the underside of the gun assembly

ensuring that it is tight. Do not over tighten as this

could damage both the connectors.

10.4 High pressure lance safety lock

In order to prevent accidental operation of the

high-pressure lance, the gun is fitted with a safety

lock. To engage the safety lock (picture 1, part 5)

release the trigger and engage the safety lock

between the trigger and the gun body.

10.5 Connecting the hose

The water inlet connector is fitted with a particle filter and if not fitted must be fitted prior to

use.

Do not run the unit without filter.

Based on the water quality the filter must be checked and cleaned from time to time.

In case there are dirt particles in the water supply, the filter must be cleaned before each use.

Otherwise the performance of the unit will be decreased or the pump might get damaged.

Screw the male, water inlet connector onto the

pressure washer water inlet. (picture 3, part 22)

Fit a female hose connector to your hose pipe and

then connect the female connector onto the male

connector.