Operation Manual

POW63700 EN

To obtain the desired cutting height, the front and rear axles are repositioned on the underside

of the mower housing.

Warning! Disconnect the mower from the power supply and ensure the

blade has stopped coasting before adjusting the height.

8.1 To adjust the front wheel cutting height position (Fig. 2a)

 Turn the mower upside down.

 Pull the wheel axle towards the front of the mower.

 Locate the wheel axle into the desired cutting height adjustment position.

Note: Make sure that both front right and left wheels are located in the same

cutting height adjustment position.

8.2 To adjust the rear wheel cutting height position (Fig. 2b)

 Turn the mower on its side.

 Pull the rear wheel axle towards the mower’s catcher flap.

 Locate the wheel axle into the desire cutting height adjustment position.

Note: Make sure that both rear right and left wheel are located in the same

cutting height adjustment position.

8.3 Cutting height positions (Fig. 2c)

 25 mm (lowest cutting height position)

 40 mm

 55 mm (highest cutting height position)

9 OPERATION

9.1 Connect to power supply.

Before you connect the equipment to the mains supply make sure that the data on the rating

plate are identical to the mains data.

Connect the plug to an extension cable. It is imperative to secure the extension cable with the

cable grip.

Warning! Before connecting to the mains supply, always check the switch

is in off position. Connect the plug into the RCD protected power supply.

9.2 Starting (Fig. 3)

Caution! Do not start the mower if it is standing in long grass.

Press the safety button (A) of the switch assembly and then pull the switch lever (B) against

the bar. Keep the switch lever held whilst releasing the safety button. To stop the mower

release the switch lever and it automatically returns to its off position.

ATTENTION : After switching off, the cutting blade will go on turning for a

few seconds, make sure the blade has come to a complete standstill.

CAUTION: Do not rapidly switch off and on.