Operation Manual

POW63700 EN

 Stop the blades if the lawnmower has to be tilted for transportation when crossing

surfaces other than grass and when transporting the lawnmower to and from the area to

be mowed.

 Do not tilt the machine when starting or switching on the motor, except if the machine has

to be tilted for starting in long grass. In this case, do not tilt it more than absolutely

necessary and tilt only the part which is away from the operator. Always ensure that both

hands are in the operating position before returning the machine to the ground.

 Switch on the lawnmower according to instructions and with feet well away from the

blades.

 Do not put hands or feet near or under rotating parts.

 Keep clear of discharge opening at all times.

 Never pick up or carry the lawnmower while the motor is running.

 Remove the plug from the socket:

 whenever you leave the machine

 before clearing a blockage

 before checking, cleaning or working on the lawnmower

 after striking a foreign object. Inspect the lawnmower for damage and make repairs as

necessary if the lawnmower starts to vibrate abnormally (check immediately).

 Keep all nuts, bolts and screws tight to be sure that the lawnmower is in safe working

condition.

 Check the grass catcher frequently for wear or deterioration.

 Replace worn or damaged parts for safety.

7 ASSEMBLY

The lawn mower is delivered unassembled. The complete push bar must be assembled before

using the lawn mower. Follow the operating instructions step-by-step and use the pictures

provided as a visual guide to easily assemble the machine.

7.1 Preparation

 Put the cable hook on upper handle (Fig. 1a)

 Connect upper and lower handles with supplied screws and knobs. (Fig. 1b)

 Insert the handles into the mower body. (Fig. 1c)

 Fit each wheels over the axles, secure in place with the “R” pins.

 Fix the cable holders. (Fig. 1e)

 Grasse collection box assembly. Assemble two halves and fix them together. (Fig. 1f)

 Lift the flap and place the grass box over the lugs. (Fig. 1g)

 Press the wheel covers into place (Fig. 1h).

8 SETTING THE CUTTING HEIGHTS

To obtain the desired cutting height, the front and rear axles are repositioned on the underside

of the mower housing.

Important! Adjust the cutting height only when the engine is switched off

and the power cable has been disconnected.

Before you begin to mow, check to ensure that the blade is not blunt and that none of the

fasteners are damaged. To prevent any imbalance, replace blunt and/or damaged blades. To

carry out this check, first switch off the motor and pull out the power plug.