Instruction Manual

17
Fig.17
Fig.18
Fig.15 Fig.16
OPERATION OF THE REMOTE CONTROL CHANNEL 14
Enable PIR* from remote control
Take the supplied radio control unit cod. PTVTEL
• By using the "+" and "-" buttons select channel 14 Fig.15 and immediately after press
the button as shown in Fig. 16
• The blue LED on the heater starts flashing twice to confirm the operation Fig.17
Disable PIR* from remote control
Take the supplied radio control unit cod. PTVTEL
3
4
• NOT INCLUDED
ACCESSORY
COD.ST15
3x
2x
• When switched on for the first time with the power supply switched on (230Vac),
pressing the ON button will set the controller to idle (red LED).
• During the following starts, pressing the ON button will set the controller to the last
power selection set (status MEMORY).