Instruction Manual

16
Fig.11
Fig.13
MED - MAX
Fig. 12, 14
2
When switched on for the first time with the power supply switched on (230Vac), pressing the ON button
will set the controller to idle (red LED).
During the following starts, pressing the ON button will set the controller to the last power selection set
(status MEMORY).
Switching ON
Fig.9
Fig.10
Setting power.
1
OPERATION OF THE REMOTE CONTROL CHANNEL 1….12
MIN
Take the radio remote control unit cod. PTVTEL:
•
On channel «1», press the button as shown in fig. 11
•
Yellow LED lights up Fig.12 medium power
•
On channel «1», press the button as shown in fig. 13
•
Green LED lights up Fig.14 maximum power
Take the radio command code no. PTVTEL:
• On channel «1», press the button as shown in fig. 9
•
Red LED lights up Fig.10
The LED changes colour
( Red, Yellow, Green ) according to the
set power level.