User`s guide

6-4 VariQuest
®
Cutout Maker 1800 User’s Guide
Error Codes
Tips
Error Codes
The following table describes the Error Codes that may appear on the control
panel and corrective action required to correct the problem.
Note: Error codes contain a 2nd digit that the user does not have to be concerned
with.
Error Codes
Message Displayed Corrective Action
Cutter stalled. Check mat
for obstructions. Press
stop to clear error.
Error #3 or Error #4
1. Verify that there are no obstructions on the mat.
2. Insert new material.
3. Verify that the correct material type is selected in the VariQuest
Software on the Design Center touch computer or the PC.
4. Press STOP to clear error.
5. Try again.
6. If the error persists, contact your VariQuest
®
dealer.
Sensor error. Check mat for
obstructions.
Press stop to clear error.
Error #5, Error #6 or Error
#13
1. Verify that here are no obstructions on the mat.
2. Press STOP to clear error.
3. Try again.
4. If the error persists, contact your VariQuest
®
dealer.
Tip Sensor error. Check
blade position. Ensure mat
is not over sensor.
Press stop to clear error.
Error #8
1. Ensure that the mat is not over the tip sensor.
2. Remove any obstructions from the tip sensor (see “Clean Tip
Sensor” on page 5-11).
3. Open gantry cover.
4. Verify that the blade holder assembly is rotated to the
operating position as shown in Step 8 on page 5-6.
5. Rotate the blade holder 90° toward the front of the unit as
shown in “Replacing the Cutting Blade” on page 5-2.
6. Ensure that the blade is installed in the blade holder.
7. Rotate the blade holder assembly
90° to its operating position
as shown in Step 8 page 5-6.
8. Close gantry cover.
9. Press STOP to clear error.
10. Try again.
11. If the error persists, contact your VariQuest
®
dealer.
Job contains invalid data
and cannot be cut. Press
stop to clear error.
Error #9 or Error #10
1. Select a different object size in the VariQuest
®
Software on
the Design Center touch computer or the PC.
2. Press STOP to clear error.
3. Try again.
4. If the error persists, contact your VariQuest
®
dealer.