User`s guide

VariQuest
®
Cutout Maker 1800 User’s Guide 6-3
Troubleshooting
Tips
Paper scrunching during cutting.
1. Adjust the cutting blade depth 1 step negative (see “Loading
Material” on page 4-2).
2. Try cutting again. If condition persists, repeat step 1.
3. Clean tip sensor. See “Clean Tip Sensor” on page 5-11.
Paper moves while cutting.
1. Mat is dirty, clean with isopropyl alcohol.
2. Scrap paper is too small, use larger scrap paper.
Note: Smaller scrap sizes may move on the cutting mat. If this
occurs, you may need to use a larger piece of scrap, or the
movement may be corrected by placing another piece of paper next
to the paper you are cutting to increase vacuum suction.
3. Rotate mat 180
o
.
4. Replace mat.
Blade does not retract during blade
change procedure.
1. Remove blade.
2. Rotate head down, depress blade release button, cycle power.
3. Rotate head up, depress blade release button, cycle power.
4. Depress blade release button, insert blade, cycle power.
Troubleshooting (Continued)
Diagnosis Required Action