User`s guide

VariQuest
®
Cutout Maker 1800 User’s Guide 4-3
Typical Operating Sequence
Operating Example
Typical Operating Sequence
Important
The VariQuest
®
Cutout Maker 1800 can be used only with the VariQuest
®
Design Center Software. The VariQuest
®
Design Center Software is installed on
your VariQuest
®
Design Center or PC. Refer to the separate VariQuest
®
Design
Center User’s Guide for software installation.
After loading the materials as described in “Loading Material” on page 4-2, the
Cutout Maker control panel will display instructions similar to the following
example.
Operating Example
To load cutout material:
1. Position the material on the Cutout Maker. Make sure that the top left corner is
flush with the guides on the Cutout Maker bed.
2. Press GO.