Instruction manual

6-4  Troubleshooting VariQuest™ Cutout Maker 1800
Cutout Maker Error Codes
The following table describes the Error Codes that may appear on the control panel and corrective action
required to correct the problem.
Note: Error codes contain a 2nd digit that the
user does not have to be concerned with.
Error Codes
Message Displayed Corrective Action
Cutter stalled. Check
mat for obstructions.
Press stop to clear
error.
Error #3
or
Error #4
1. Verify that there are no obstructions on the mat.
2. Insert new material.
3. Verify that the correct material type is selected in the VariQuest
TM
software on the
Design Center or the Personal Computer.
4. Press STOP button to clear error.
5. Try again.
6. If the error persists, contact your dealer.
Sensor error. check
mat for obstructions.
Press stop to clear
error.
Error #5
or
Error #6
or
Error #13
1. Verify that here are no obstructions on the mat.
2. Press STOP button to clear error.
3. Try again.
4. If the error persists, contact your dealer.
Tip Sensor error. Check
blade position. Ensure
mat is not over sensor.
Press stop to clear
error.
Error #8
1. Ensure that the mat is not over the tip sensor.
2. Open gantry cover.
3. Verify that the blade holder assembly is rotated to the operating position as shown in
Step 8 on page 5-6.
4.
Rotate the blade holder 90
o
towards the front of the unit as shown in Step 3 on page 5-3.
5. Ensure that the blade is installed in the blade holder.
6. Rotate the blade holder assembly 90
o
to its operating position as shown in Step 8
page 5-6.
7. Close gantry cover.
8. Press STOP button to clear error.
9. Try again.
10.If the error persists, contact your dealer.