Instruction manual

VariQuest™ Cutout Maker 1800 Operating the Cutout Maker  4-3

Typical Operating Sequence

Important: The VariQuest

Cutout Maker 1800 can be used only with the VariQuest

Design Center

Software. The VariQuest

Design Center Software is installed on your VariQuest

Design Center 1000

PC. See the separate manual for VariQuest

Design Center Software user information.

After you have set up the cutout materials as described in “Loading Material on the Cutout Maker” on

page 4-2, the Cutout Maker control panel will display instructions similar to the following example.

Operating Example

Load Cutout Material

1. Position the material on the Cutout Maker. Make sure that the top left corner is flush with the

guides on the Cutout Maker bed.

2. Press “GO”.

Smooth Paper/Start Cut Job

1. Smooth the paper on the cutting mat.

NOTE: Smoothing paper on the cutting mat ensures a clean cut.

2. Press “GO” to start the cut job. Once cutting is complete, you can remove your cutout from

the cutting bed.

1. Load heavy

construction

Left - any color

paper:

2. Press GO

1. Smooth paper

2. Press GO to

start cutting

Load Cutout Material Smooth Paper/Start Cut Job