Instruction manual

3-6  Getting Started VariQuest™ Cutout Maker 1800
Connecting to a Personal Computer
The Cutout Maker provides a standard interface for connecting to a computer (USB connector).
Connect one end of the cable provided to an available USB connector on the computer, and
connect the remaining end to the USB connector on the Cutout Maker. Power up the Cutout
Maker and the computer, and install the VariQuest
TM
Design Center Software.
Note: Refer to the separate VariQuest
TM
Design Center 1000 User’s Guide for software
Installation
Cutout Maker
USB Connector
USB Plugs
USB Cable