Instruction manual

VariQuest™ Cutout Maker 1800 Getting Started  3-5
Connecting to the VariQuest
TM
Design Center 1000 or a Personal
Computer
Important!
Use the USB cable supplied with the Cutout Maker to connect to the VariQuest
TM
Design Center 1000 or a PC. The USB cable complies with FCC “Rules and
Regulations,” Part 15 for Class A Equipment using fully shielded six-foot data
cables. Use of longer cables or unshielded cables may increase radiation emissions
above the Class A limits. The power cord must be inserted into the receptacle on the
side of the Cutout Maker before connecting the communication cables.
Connecting to a VariQuest
TM
Design Center 1000
Design Center 1000
Rear Panel