Instruction manual

3-4  Getting Started VariQuest™ Cutout Maker 1800
Setting up the Cutout Maker
Connecting the Power Cord
Connect the power cord to the Cutout Maker. Then insert the power plug into a grounded three-
prong wall socket:
1. Set the power switch to its “0” (OFF) position.
2. The power cord has a three-prong female connector on one end that must be inserted into the
male power receptacle on the left side of the Cutout Maker.
3. Plug the other end of the cord into an appropriate AC outlet.
Always connect the power
cord to the Cutout Maker
before inserting the plug into a
wall socket
Never operate the Cutout Maker
in an area where it can get wet
Wall Socket
Cutout Maker
Power Plug
Power Cord
Receptacle
USB Cable
Power Cord
Receptacle
Power Switch
0 (OFF)
1 (ON)