User`s guide

2-4  Upgrading Components VariQuest™ Design Center 1000
Installing a CompactFlash card
The CompactFlash card reader uses an IDE (integrated drive electronics) interface and only
supports storage cards. Plug and play is not supported, so cards have to be installed before you turn
the DC1000 on. Follow the instructions below to install a CompactFlash card. After installing a card,
replace the cover to prevent the card from being accidentally removed while the power is on.
1. Remove the screw and the card reader
cover.
2. Insert the CompactFlash card as shown.
Caution: Inserting the card incorrectly
can damage the connector pins. Be sure
the card is oriented as shown and insert it
gently.
3. To remove a card, press the eject button
and pull the card out.
4. Replace the cover and screw.