User`s guide

VariQuest
®
Awards Maker 400 User’s Guide 5-3
7. Lower the print-head module and insert the bare roll into the top holder by
pushing in the spring side first.
8. Close the print head by firmly pressing down the print head module until you
hear a click on each side. Snap in one side at a time to ensure proper closure.
9. Turn the print head module flywheel away from you a few times to ensure the
ribbon is tightly wound.
Tip! To ensure secure closure, tap each release lever with your finger a few
times. If it springs up, that side is not properly closed. If it's tightly locked, that
side has been properly closed.
10. Close the top cover and turn on the printer. You are now ready to send print
jobs to the Awards Maker 400 using your VariQuest
®
Design Center
Software.
Flywheel