Operating instructions

8
A/S WODSCHOW & CO.
Industrisvinget 6.
DK-2605 Brøndby
Denmark
Phone: [phone]
Telefax: 43 43 12 80
www.wodschow.dk
INSTALLATION - CLEANING - MAINTENANCE
INSTALLATION:
The mixer can be placed direct on the floor. Foundation bolts in the floor are only necessary under special conditions, e.g. in
ships. If the 20 L mixer is placed on a bench stand, it
must be fastened with the enclosed bolts, see page 2. If the floor is not
level, the position of the mixer can be corrected by loosening the screws (18) placed at the bottom of the outer left side of the
mixer, whereafter the legs can be turned, see page 6. When the mixer is placed correctly, the screws are tightened again.
Ensure that the voltage, phase and hertz printed on the identification plate of the mixer are correct compared with that of the
place of installation. The identification plate is located at the top of the right side of the mixer. Be sure the mixer is properly
connected to the incoming power supply and that the ground or earth connection is made. If the mixer is provided with a five core
cable, the mixer must also be connected to 0 (N). The arrow on the front of the planetary head (see picture 2 page 1), is showing
the direction of rotation of the planetary head. On 3-phase motors the direction of rotation can be changed by interchanging 2
phases of the connecting cable or of the motor. Electric connections must be made in accordance to local regulations.
NOISE LEVEL:
The constant noise level of the workplace of the operator is 72 db (A)
CLEANING:
The mixer should be cleaned daily or after use. Wash by means of a soft brush and pure water. Synthetic detergents should be
used with care, as they destroy the lubricants of the mixer. Washing with a hose is
not recommended. Bowls and mixing tools
should be washed in detergents which do not attack aluminium. The suppliers of detergents will be able to recommend the right
type.
LUBRICATION AND MAINTENANCE:
When the mixer is used regularly the varispeed system must be lubricated
approx. once per month. When the mixer is intensively used, or often used
without changes in the speed, the lubrication intervals should be more often.
DIRECTIONS FOR LUBRICATIONS:
Start the mixer and increase the speed up to approx. 50%. Stop the mixer
and take off the top cover of the mixer by removing the 2 screws (2), see
page 2-3.
On top of the shafts of the pulley sets there is a grease nipple, one on each
pulley set. Press the grease through the grease nipples until the grease gun
feels hard, or until grease is pressed out between the shaft and the pulleys.
Put the top cover back,
and remember to put in the 2 screws securing
the cover.
Before starting the mixer, the lid must be mounted.
Start the mixer, and set the speed back to low speed.
Stop the mixer and fill up the grease gun with new grease to be ready for the
next lubrication.
TYPES OF GREASE:
Grease for the shafts of the pulley sets: CASTROL LMX.
When repairing the planetary head which is greased for life, the grease CASTROL Molub Alloy 936SF Heavy should be used
in gear wheel and gear wheel rim. The needle bearings of the planetary head must not be greased with this type of grease.
Grease for gear for attachment drive, if any: ESSO Fibrax EP 370
Only this type of grease can be used, and it must not be mixed with other types of grease.