User`s manual

TROUBLESHOOTING AND MAINTENANCE
A
02.9690.0001 A 15 April 2010 65
Beam Spreader Removal for Fixed Beam Applications
Tools:
• #2 Phillips screwdriver
• Slotted screwdriver
WARNING: Ensure that power is completely removed from luminaire before attempting any work.
Always wear eye protection and proper gloves when performing this procedure.
To remove beam spreader assembly for fixed beam applications:
Step 1. Remove power from luminaire and allow unit to completely cool.
Step 2. Carefully set luminaire on upper enclosure, rotate head as shown in Figure A-2, and engage
tilt lock.
Figure A-6: VLX™ Wash Luminaire
Step 3. Remove front head cover by unlatching both head cover latches. Please note that one side of
front cover is secured by a safety tether. Locate clip attached to luminaire and unclip tether.
Step 4. Gently slide front head cover over optic assembly and set aside.
Luminaire Head
CAUTION:
Remove power and
allow fixture to cool.
Upper Enclosure
Front Cover Latch
Front Head Cover
(one on each side of cover)