User`s manual

VARI❋LITE® - VLX™ WASH LUMINAIRE USER’S MANUAL
48 15 April 2010 02.9690.0001 A
Menu System Function Chart
The following is a detailed look at the internal menu system.
Table 4-1: VLX Wash Menu System Chart
1st Level 2nd Level 3rd Level 4th Level 5thLevel
Address XXX value 1 thru 512
Configure
Fixture
configuration
settings
Pan/Tilt
Pan and Tilt
movement
Movement Position recovery Enable
Disable
Dim Curve Fixture dimming
operation
Square Law Dimming curve
(Default)
Linear Standard linear dimming
curve
Power Level Settings for
LED operation or calibration
Power Setup
Four levels of
operation for fans and LEDs
(Note, Quiet will reduce levels to
minimize heat in fixture)
Normal Default
Quiet
For reduced
noise
Constant Fans
Sets fans to a set
speed level
Level Sets to a set
level
LED Cal Selects whether to
use factory calibration or not
LED Correction Sets LEDs to
factory calibration level
ON
OFF
Display
Display Illumination Off Time Selects display off time ON On indefinitely
30 Sec
Off in 30
seconds
5 Min
Off in 5
minutes
10 Min
Off in 10
minutes
Disp Tilt Display orientation -
Factory default is Auto and other
functions are currently disabled
from selection.
Auto (Default)
Up - Currently
Disabled
Down - Currently
Disabled
CMD Lock Selects whether
to set Command Lock - to
lock-out access to various
settings from the console
using the Control Channel
Note: Resetting to Defaults
(DMX 5 - 7 on Control
Channel) will turn Command
Lock OFF.
On Control Channels - Mode,
Dimmer Curve, Color Calibration
(On/Off) - control, via the
console, is disabled.
Off (Default) Control Channels -
Mode, Dimmer Curve, Color
Calibration (On/Off) - control, via
the console, is enabled.
Reset Default Restores
fixture to factory default
OK? Asks (confirms) to execute
restoration of factory defaults of
fixture
Menu system description continued on next page.