User`s manual

VARI❋LITE® - VLX™ WASH LUMINAIRE USER’S MANUAL
16 15 April 2010 02.9690.0001 A
Installing in Truss:
Step 1. Using two people, lift luminaire into mounting position.
Step 2. Secure in place with truss hook. Ensure truss hook hardware that locks hook in place (e.g.
wing bolt) is properly tightened and that luminaire is fully supported.
Step 3. Attach safety cable (as required) as follows:
a. Connect one end of cable to luminaire handle.
b. Loop at least once around truss/pipe and attach other end of cable to other handle.
Step 4. Connect power and data cables according to procedure given in “Connecting Data and
Power” on page 17.
WARNING: DO NOT connect or disconnect energized power cable at fixture (under load). Turn off
circuit breaker (or completely de-energize circuit) before connecting or disconnecting power cable at
fixture. Power is only removed from the fixture by disconnecting power cable from source or turning
off source circuit breaker.
Step 5. Be sure pan and tilt locks are disengaged (refer to “Luminaire Overview” on page 6 for
details) to allow full head and yoke movement.
Figure 2-5: Hanging Configuration and Dimensions
22.0 in
559.0 mm
(on centers)
27.4 in
696.0 mm
17.5 in
445.0 mm
21.5 in
546.0 mm
Safety Cable (not included)
Top View
Use enclosure handles for safety cable anchor
points (refer to Top View illustration below).
Safety Cable:
Recommended for all
hanging installations
and may be required
by local codes.
Head Tilt Lock