User`s manual

VARI❋LITE® - VL3500™ SERIES LUMINAIRE USER’S MANUAL
58 31-July-2004 02.9678.0019 0
Troubleshooting
Error Messages
If a problem occurs during luminaire calibration, at the end of the calibration sequence the Menu
Display will cycle through any applicable error message(s) until the end of the list is reached. To
review the error messages again, it will be necessary to access them using the Status function.
To access error messages:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Fixture appears. Press [Enter].
Step 3. Press [Up]/ [Down] arrows to access Status. Press [Enter]. (Display will now scroll
through any error messages or display OK if no errors.)
Table A-1: Error Messages
Display Message
OK No Errors Found
Pan/No Sens Pan sensor not found.
Pan/Encoder/Fail Pan encoder failure.
Tilt/No Sens Tilt sensor not found.
Tilt/Encoder/Fail Tilt encoder failure.
Index1/No Sens Gobo 1 Index sensor not found.
RotGobo/No Sens Rotating Gobo wheel sensor not found.
FixGobo/No Sens Fixed Gobo wheel sensor not found.
Dimmer/No Sens Dimmer sensor not found.
Cyan/No Sens Cyan sensor not found.
Yellow/No Sens Yellow sensor not found.
Magenta/No Sens Magenta sensor not found.
ColWheel/No Sens Color wheel sensor not found.
CTO/No Sens CTO sensor not found.
Zoom/No Sens Zoom sensor not found.
Edge/No Sens Edge sensor not found.