User`s manual
Table Of Contents
- Vari-Lite VL3500(TM) Series Luminaires
- How To Obtain Warranty Service
- Compliance Notice
- Safety Notice
- Sicherheitshinweise
- Notes de sécurité
- Aviso sobre Seguridad
- Table of Contents
- Introduction
- Description
- Installation
- Operation
- Menu System
- Troubleshooting and Maintenance
- Technical Specifications
VARI❋LITE® - VL3500™ SERIES LUMINAIRE USER’S MANUAL
16 31-July-2004 02.9678.0019 0
Addressing
Program Starting Address
The address setting for DMX console controlled systems is entered using the Menu Display (refer to
“Menu Operation” on page 46). The luminaire retains the DMX address even if power is removed.
Note: Refer to your console operating instructions for specific information regarding its addressing
requirements.
Program a DMX starting address:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Address appears. Press [Enter].
Step 3. Press [Up] / [Down] arrows to enter starting address.
Step 4. Press [Enter] to set.
Program Starting Address Without Calibrating
Luminaire
It is possible to bypass the calibration sequence and go directly to the Menu Display programming in
order to pre-program an address setting.
Program starting address without calibrating luminaire:
• While powering up luminaire, press and hold [Menu]. Program address as in Program Starting
Address above.
• Press and hold [Menu] until display changes from "Starting" to the DMX address.
Note: The luminaire will require a reset to restore control.