Service manual

VARI❋LITE® - VL3500™ SPOT LUMINAIRE SERVICE MANUAL
32 02.9678.0018 A
Tilt Motor Assembly Replacement
VL Part No: 21.9678.6865
Repair Procedure
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. Remove tilt-side yoke leg cover.
Step 3. Remove motor connector.
Step 4. Remove tilt motor assembly as indicated:
a. Remove four screws securing tilt motor while holding motor to prevent it from falling.
b. Remove two tensioning springs.
c. Loosen tilt belt from around gears.
d. Disconnect two connectors from tilt sensor board.
e. Remove tilt motor assembly.
Step 5. Install in reverse making sure not wires get pinched.
Figure 2-16: Tilt Motor Assembly Replacement
Tilt Motor
Head not shown for clarity.
NOTE:
Assembly
Spring
Sensor
Bracket
Tilt Belt