User`s manual

MENU SYSTEM : MENU FUNCTIONS
4
02.9678.0001 A 20-Aug-03 49
GoboX Gobo Wheel Specifies one of three rotating gobo wheels for manual control. (X = 1, 2 or 3)
Head Mtr Head Motor Configures head movement options.
IndexX Gobo Index Specifies rotating gobo index for manual control. (X = 1, 2 or 3)
Inv Pan Invert Pan Reverses pan action for special focus requirements.
Inv Tilt Invert Tilt Reverses tilt action for special focus requirements.
Lamp Lamp Accesses lamp power-up options, reset and information (Config) or tests
Lamp function (Test).
Lamp OFF Lamp is Off Configures arc luminaire so that lamp will not strike upon power up.
Lamp ON Lamp is On Configures arc luminaire so that lamp will strike upon power up.
LampHour Lamp Hours Displays total number of lamp operating hours.
Lum Id Luminaire ID Displays unique luminaire ID number.
Magenta Magenta Specifies magenta parameter for manual control (Manual) or testing (Test).
Manual Manual Accesses options for luminaire mechanism control by entry of data values.
Movement Movement Enables or disables pan and tilt movement.
OFF Off Turns off a function.
OK Okay Indicates calibration has completed and no errors have occurred.
OK? Okay? Prompt for pressing [Enter] before an action is executed.
ON On Indefinitely Sets Menu Display to stay on until programmed otherwise (Display) or turns
on a function.
Pan Pan Specifies pan function for manual control (Manual) or testing (Test).
Pan/Tilt Pan/Tilt Accesses pan and tilt options for focus swap function, movement enable/dis-
able, manual control and testing.
PASS Test Pass Indicates that a test has passed.
Power Lamp Power Accesses options to turn lamp on or off.
Power Up Power Up Accesses options for lamp power up state.
PROG Programming Currently programming the new version of software.
Re-Cal Recalibrate Recalibrates luminaire.
ResetDef Reset Defaults Resets default system configuration values.
ResetLmp Reset Lamp Resets lamp hour and strike counters. (For use when new lamp is installed.)
RotGoboX Rotating Gobo Specifies rotating gobo for testing (Test). (X = 1, 2 or 3)
RUN TEST Run Test Indicates that a mechanism test is in progress.
Sensor Sensors Accesses sensor types for diagnostic testing.
Setup Setup Accesses unit model type options (do not change).
Status Status/Error Allows scrolling through error list or displays OK if no errors.
Strobe Strobe Specifies strobe function for manual control (Manual) or testing (Test).
STST Sensor Test Indicates that a system sensor test is in progress.
Swap Swap Swaps pan/tilt action for special focus requirements.
Test Test Accesses diagnostic tests for internal mechanisms.
Tilt Tilt Specifies tilt function for manual control (Manual) or testing (Test).
Version Version Displays current software version date and time (in two pages).
Zoom Zoom Function Specifies zoom function for manual control (Manual) or testing (Test).
Table 4-2: Menu Function Definitions (Continued)
Display Definition Purpose